Connects directly to the RV waste outlet. Eliminates 3" (75 mm) sewer hose. Garden hose discharge port. Fresh water rinse capabilities. Remote handheld on/off switch with 6' (1.8 m) wire harness and fuse. Ability to dump longer distances. Ability to drain holding tanks at home. Easy clean up and storage. Rugged portable storage case. USCG and CSA listed. Pump: self-priming flexible impeller with stainless steel wearplate. Impeller: Jabsco nitrile compound. Macerator: stainless steel Cutter reduces particle size to 1/8" (4 mm) maximum. Seal: lip type. Ports:inlet 3" (75 mm) RV connector, outlet garden hose. Motor: 12V DC permanent magnet type, fully enclosed, with stainless steel shaft. Intermittent duty only. Weight: 6 lb (2.8 kg). Case size: 12" x 13" x 5.5"(300 mm x 315 mm x 140 mm). This pump should be used in accordance with EPA sanitation regulations. 5/8" (16 mm) hose size, 25 feet (7.5m) maximum hose length. 3/4" (19 mm) hose size, 50 feet (15m) maximum hose length. Is the ideal solution for emptying holding tanks on recreational vehicles and avoiding dump stations. The macerator section grinds waste down to a particle size of 1/8" maximum so it can easily be pumped through a garden hose. Empties a typical 40-gallon holding tank in less than 5 minutes. Do not run more than 15 minutes continuously. The 18555-series waste pump will macerate and pump all waste and tissue normally found in recreational vehicle waste systems. IT WILL NOT HANDLE HARD SOLID OBJECTS, SANITARY NAPKINS OR RAGS. Recommended lengths are based on horizontal discharge. Longer discharge runs create higher resistance and may result in the pump motor over heating. 12 VDC.
